Welcome to the AngelSense Support Center

Removing the battery on GPS 1

1. With the back panel facing you, use a screwdriver to remove the two screws to release the back cover. Then lift up the back cover from the notch at the bottom of the device.
 
 
2. Take the battery out
3. Put the battery back in, inserting the contacts side of the battery first
4. Gently push the battery cover downward until it locks into place. Then fasten the two screws on the back cover.
 

 

NOTE: When purchasing your AngelSense Kit, if no device is chosen the default device is the GPS 2 device. 

 

Related Articles

Advanced Troubleshooting Steps